Toyota RAV4 manuals

Toyota Sienna Service Manual: Outside moulding

COMPONENTS

COMPONENTS

Installation
1. INSTALL ROOF DRIP SIDE FINISH MOULDING When exchanging the clips Remove the tape that remains on the mounting surface of the vehicle body and then clean the surface with white gasolin ...

Removal
1. REMOVE OUTSIDE MOULDING Put protective tape around the outside moulding. Using a heat light, heat the moulding between 40 to 60 C (104 to 140 F). NOTICE: Do not heat the moulding ex ...

Other materials:

Inspection
1. INSPECT LOWER BALL JOINT ASSEMBLY FRONT LH (a) As shown in the illustration, flip the ball joint stud back and forth 5 times, before installing the nut. (b) Using a torque wrench, turn the nut continuously at a rate of 3 - 5 seconds per 1 turn and take the torque reading on the 5th tur ...

Evap monitor (key-off type)
(a) Preconditions The monitor will not run unless: The fuel tank is less than 90% full. The altitude is less than 8000 ft (2450 m). The vehicle is stationary. The engine coolant temperature is between 4.4°C and 35°C (40°F and 95°F). The intake air temperature is between 4.4°C and ...

Rear Airbag Sensor RH Circuit Malfunction
DTC B1154/38 Rear Airbag Sensor RH Circuit Malfunction DESCRIPTION The rear airbag sensor RH circuit consists of the center airbag sensor assembly and rear airbag sensor RH. If the center airbag sensor assembly receives signals from the rear airbag sensor RH, it judges whether or not the ...

© 2011-2026 Copyright www.tsienna.net