Toyota Sienna Service Manual: Park / neutral position switch

Automatic transaxle fluid

On-vehicle inspection 1. CHECK FLUID LEVEL HINT: Drive the vehicle so that the engine and transaxle are at normal operating temperature. Fluid temperature: 70 to 80°C (158 to 176°F) (a) P ...

Removal

1. REMOVE BATTERY 2. REMOVE AIR CLEANER ASSEMBLY HINT: (See page EM-26) 3. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY (a) Remove the nut from the control shaft lever. (b) Disconnect the ...

Other materials:

Installation
1. INSTALL REAR NO. 2 SEAT ASSEMBLY RH  Place the rear No. 2 seat assembly RH in the cabin. NOTICE: Be careful not to damage the body.  Install the seat with the bolt. Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)  Install the locus cable RH with the bolt. Torque: 29 N*m ( ...

Removal
1. DISCHARGE FUEL SYSTEM PRESSURE HINT: See page FU-1. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 3. REMOVE NO. 1 ENGINE UNDER COVER 4. DRAIN ENGINE COOLANT (See page CO-6) 5. REMOVE FRONT WIPER ARM HEAD CAP (See page WW-4) 6. REMOVE FRONT WIPER ARM RH (See page WW-4) 7. REMOVE FRO ...

Short to B+ in Driver Side Squib 2nd Step Circuit
DTC B1183/22 Short to B+ in Driver Side Squib 2nd Step Circuit DESCRIPTION The driver side squib 2nd step circuit consists of the center airbag sensor assembly, the spiral cable and the steering pad. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1183/22 ...