Toyota Sienna Service Manual: Reassembly
1. INSTALL BLOWER WITH FAN MOTOR SUBASSEMBLY
2. INSTALL BLOWER MOTOR CONTROL (for Automatic Air Conditioning System)
3. INSTALL BLOWER RESISTOR (for Manual Air Conditioning System)
4. INSTALL COOLING UNIT DAMPER SERVO SUBASSEMBLY
5. INSTALL AIR REFINER ELEMENT
Disassembly
1. REMOVE AIR REFINER ELEMENT
(a) Release the 2 claw fittings and remove the air filter
sub-assembly.
(b) Remove the air refiner element from the air filter
cover plate.
2. REMOVE COOLING ...
Installation
1. INSTALL BLOWER ASSEMBLY
(a) Install the blower assembly.
(b) Install the bolt, the 2 screws and the nut.
Torque: Bolt A
9.8 N*m (100 kgf*cm, 87 in.*lbf)
(c) Install the 2 clamps and 2 nu ...
Other materials:
Removal
HINT:
On the RH side, use the same procedures as on the LH side.
1. REMOVE BACK DOOR STAY SUB-ASSEMBLY LH
Remove the 2 bolts and disconnect the stay from
the body panel.
Using the screwdriver, disengage the clips and
remove the stay from the door panel.
Remove the bolt from door pa ...
Master Reset/ Voice Processing Device ON Error
DTC 01-DD Master Reset
DTC 01-E1 Voice Processing Device ON Error
DESCRIPTION
HINT:
*1: This code may be stored if the engine is started and the ignition switch is
turned to START position
again.
*2: Even if no fault is present, this trouble code may be stored depending on
the battery ...
SRS Warning Light does not Come ON
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK BATTERY
Measure the voltage of the battery.
Standard voltage:
11 to 14 V
2 CHECK CONNECTORS
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the
battery, and wait for at le ...
