Toyota Sienna Service Manual: Reassembly
1. INSTALL INSTR PNL PASS L/DOOR AIR BAG ASSEMBLY
2. INSTALL INSTRUMENT PANEL WIRE NO.2
3. INSTALL NAVIGATION ANTENNA ASSEMBLY
4. INSTALL ANTENNA CORD SUB-ASSEMBLY
5. INSTALL INSTRUMENT PANEL BOX DOOR SUBASSEMBLY NO.2
6. INSTALL INSTRUMENT PANEL FINISH PANEL RETAINER NO.1
7. INSTALL INSTRUMENT FINISH PANEL RETAINER LOWER NO.2
8. INSTALL INSTRUMENT FINISH PANEL RETAINER LOWER
9. INSTALL DEFROSTER DUCT BRACKET NO.1
10. INSTALL INSTRUMENT CLUSTER FINISH PANEL REINFORCEMENT
11. INSTALL INSTRUMENT PANEL FINISH PANEL RETAINER LOWER NO.3
12. INSTALL SIDE DEFROSTER NOZZLE RH
13. INSTALL SIDE DEFROSTER NOZZLE LH
14. INSTALL HEATER TO REGISTER DUCT NO.3
15. INSTALL HEATER TO REGISTER DUCT NO.2
16. INSTALL HEATER TO REGISTER DUCT NO.1
17. INSTALL DEFROSTER NOZZLE ASSEMBLY
18. INSTALL SIDE DEFROSTER NOZZLE DUCT NO.2
19. INSTALL SIDE DEFROSTER NOZZLE DUCT NO.1
Disassembly
1. REMOVE SIDE DEFROSTER NOZZLE DUCT NO.1
(a) Remove the 2 screws <C> and defroster nozzle
duct No. 1.
2. REMOVE SIDE DEFROSTER NOZZLE DUCT NO.2
(a) Remove the 2 screws <C> and defrost ...
Installation
1. INSTALL INSTRUMENT PANEL SAFETY PAD SUBASSEMBLY
Using a torque wrench, install the bolt <B>.
Torque: 20 N*m (204 kgf*cm, 14 ft.*lbf)
2. INSTALL SHIFT LEVER ASSEMBLY
...
Other materials:
Body
GENERAL MAINTENANCE
1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND
BODY
(a) Tighten all the parts of the chassis when necessary.
Steering system
Drive train
Suspension
Brake system
Engine mounting, etc.
(b) Tighten all the parts of the body when necessary.
Seat belts
Seats
Doors ...
If the shift lever cannot
be shifted from P
If the shift lever cannot be shifted with your foot on the brake
pedal, there may be a problem with the shift lock system (a system
to prevent accidental operation of the shift lever). Have the
vehicle inspected by your Toyota dealer immediately.
The following steps may be used as an emergency ...
Terminals of ecu
Check tire pressure warning ecu
HINT:
Inspect the connectors from the back side while the
connectors are connected.
(a) Disconnect the tire pressure warning antenna and
receiver connector.
(b) Measure the voltage according to the value(s) in the
table below.
(c) Connect the tire pr ...
