Toyota RAV4 manuals

Toyota Sienna Service Manual: Instrument panel

Toyota Sienna Service Manual / Instrument panel

Outer mirror switch
Inspection 1. INSPECT OUTER MIRROR SWITCH ASSEMBLY (w/o Memory)  The L side of the left / right adjustment switch: Inspect the mirror switch resistance. Standard resistance (Left s ...

Precaution
1. PRECAUTION FOR VEHICLE WITH SRS AIRBAG AND SEAT BELT PRETENSIONER Some operations in this section may affect SRS airbag system. Before performing the corresponding operations, please read ...

Other materials:

Diagnostic trouble code chart
1. DTCS FOR OCCUPANT CLASSIFICATION SYSTEM If a trouble code is displayed during the DTC check, check the circuit listed for the code in the table below (proceed to the page listed for that circuit). HINT: When DTC B1150/23 is detected as a result of troubleshooting for the airbag system, pe ...

Illumination Circuit
DESCRIPTION Power is supplied to the radio and navigation assembly and steering pad switch illumination when the light control switch is in the TAIL or HEAD position. WIRING DIAGRAM INSPECTION PROCEDURE NOTICE: The vehicle is equipped with an SRS (Supplemental Restraint System) such as t ...

Perform zero point calibration of yaw rate and deceleration sensor (when using intelligent tester)
(a) Connect the intelligent tester to the DLC3. (b) Turn the ignition switch to the ON position. (c) Operate the intelligent tester to erase the codes (select "RESET MEMORY"). HINT: Refer to the intelligent tester operator's manual for further details. (d) Using the intell ...

В© 2011-2024 Copyright www.tsienna.net