Toyota Sienna Service Manual: Removal

Toyota Sienna Service Manual / Meter / Combination meter / Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

2. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Disengage the 4 clips and remove the instrument cluster finish panel sub-assembly.

3. REMOVE COMBINATION METER ASSEMBLY

REMOVE COMBINATION METER ASSEMBLY

Remove the 4 screws.
Pull out the combination meter assembly, and disconnect the connectors.

Installation

1. INSTALL COMBINATION METER ASSEMBLY Connect the connectors. Install the combination meter assembly with the 4 screws. 2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMB ...

Other materials:

Diagnosis system
1. CHECK DLC3 The vehicle's ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format. NOTICE: *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not ...

Short to GND in Front Passenger Side Squib 2nd Step Circuit
DTC B1187/55 Short to GND in Front Passenger Side Squib 2nd Step Circuit DESCRIPTION The front passenger side squib 2nd step circuit consists of the center airbag sensor assembly and the front passenger airbag assembly. The circuit instructs the SRS to deploy when deployment conditions are ...

Terminals of ECU
1. CHECK TRANSPONDER KEY AMPLIFIER Disconnect the I14 amplifier connector and measure the resistance between the terminal of the wire harness side connector and body ground. If the result is not as specified, there may be a malfunction on the wire harness side. Reconnec ...