Toyota Sienna Service Manual: Installation
1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).
- Install the rear seat 3 point type belt assembly with
the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 7-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for captain seat type).
- Install the rear seat 3 point type belt assembly with
the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
3. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY
HINT:
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type RH side).
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type RH side).
- Install the rear seat 3 point type belt assembly with
the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
4. INSTALL REAR SEAT INNER BELT ASSEMBLY
HINT:
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Install the rear seat inner belt assembly with the
bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
Removal
1. REMOVE REAR SEAT 3 POINT TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT:
Refer to the instructions for disassembly of the rear No. 1
seat assembly (for center seat).
Remove the bolt and re ...
Rear seat outer belt assembly
COMPONENTS
...
Other materials:
Horn
To sound the horn, press on or
close to the mark.
WARNINGCaution while driving
Do not adjust the steering wheel while driving.
Doing so may cause the driver to mishandle the vehicle and cause an
accident,
resulting in death or serious injury.
After adjusting the steeri ...
Disassembly
1. REMOVE FRONT SEAT SIDE TABLE LEG COVER (w/
Table)
Using a screwdriver, disengage the claws and
remove the seat side table leg cover.
HINT:
Tape the screwdriver tip before use.
2. REMOVE FRONT SEAT SIDE TABLE (w/ Table)
Remove the 4 nuts and seat side table.
Rem ...
Transmission Range Sensor Circuit Malfunction (PRNDL Input)
DESCRIPTION
The park/neutral position switch detects the shift lever position and sends
signals to the ECM.
HINT:
After confirming DTC P0705, use the intelligent tester to confirm the PNP
switch signal in the ALL menu
(to reach the ALL menu: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ...
