Toyota Sienna Service Manual: Removal

Toyota Sienna Service Manual / Seat / Rear no. 2 Seat assembly (for Manual Seat Type RH Side) / Removal

1. REMOVE REAR SEAT LEG SIDE GARNISH SUBASSEMBLY RH

REMOVE REAR SEAT LEG SIDE GARNISH SUBASSEMBLY RH

Disengage the clips and remove the seat leg side garnish sub-assembly RH.

2. REMOVE REAR NO. 2 SEAT ASSEMBLY RH

Remove the bolt and locus cable RH.
Remove the 2 bolts and rear No. 2 seat assembly RH.
Remove the rear seat headrest assembly RH.

Rear no. 2 Seat assembly (for Manual Seat Type RH Side)

COMPONENTS ...

Disassembly

1. REMOVE RH SEAT REAR SEAT RECLINING COVER Remove the 2 screws. Remove the RH seat rear seat reclining cover by pulling it out in the arrow mark direction shown in the illus ...

Other materials:

Driving in vehicle-to-vehicle distance control mode
This mode employs a radar sensor to detect the presence of vehicles up to approximately 400 ft. (120 m) ahead, determines the current vehicle-to-vehicle following distance, and operates to maintain a suitable following distance from the vehicle ahead. Note that vehicle-to-vehicle distance will ...

Stereo Component Amplifier Power Source Circuit
DESCRIPTION This circuit provides power to the stereo component amplifier. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT STEREO COMPONENT AMPLIFIER Disconnect the stereo component amplifier connector. Measure the resistance according to the value(s) in the table below. S ...

Installation
1. INSTALL REAR DIFFERENTIAL DRIVE PINION BEARING SPACER (a) Install a new bearing spacer. 2. INSTALL REAR DRIVE PINION FRONT TAPERED ROLLER BEARING (a) Install the tapered roller bearing. 3. INSTALL REAR DIFFERENTIAL DRIVE PINION OIL SLINGER (a) Install the oil slinger, as shown in the i ...