Toyota Sienna Service Manual: Removal
1. REMOVE ROOF DRIP SIDE FINISH MOULDING
- Put protective tape around the roof drip side finish moulding.
- Using a remover for the roof moulding, disengage of the clips both in the front and rear ends of the roof drip side finish moulding and then remove the roof drip side finish moulding.
NOTICE:
- Do not remove the clips.
- If the clips are damaged or removed accidentally, exchange them for supply ones.
Roof drip side finish moulding
COMPONENTS
...
Installation
1. INSTALL ROOF DRIP SIDE FINISH MOULDING
When exchanging the clips
Remove the tape that remains on the mounting
surface of the vehicle body and then clean the
surface with white gasolin ...
Other materials:
Stowing the third seats (manual seats)
Before stowing or returning third seat, remove any items from the floor
area to prevent interference with moving parts.
Before stowing the third seats
Lower the center head
restraint to the lowest position
, and stow the
seat belt buckles.
Stow the center seat belt.
Stowing ...
Short to GND in Curtain Shield Squib LH Circuit
DTC B1167/85 Short to GND in Curtain Shield Squib LH Circuit
DESCRIPTION
The curtain shield squib LH circuit consists of the center airbag sensor
assembly and the curtain shield
airbag assembly LH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1167/85 is ...
For manual air conditioning system
ON-VEHICLE INSPECTION
1. INSPECT AIR INLET CONTROL SERVO MOTOR
(a) Remove the air inlet control servo motor.
(b) Connect the positive (+) lead from the battery to
terminal 5 and negative (-) lead to terminal 1, then
check that the lever turns to "RECIRCULATION"
side smoothly.
...
