Toyota Sienna Service Manual: Roof drip side finish moulding

Installation

1. INSTALL REAR DOOR GLASS WEATHERSTRIP Install the rear door glass weatherstrip. 2. INSTALL SLIDE DOOR WINDOW ASSEMBLY 3. INSTALL REAR DOOR GLASS RUN 4. INSTALL REAR DOOR TRIM BOARD SUBASSE ...

Removal

1. REMOVE ROOF DRIP SIDE FINISH MOULDING Put protective tape around the roof drip side finish moulding. Using a remover for the roof moulding, disengage of the clips both in the front an ...

Other materials:

If the engine will not start
If the engine will not start even though correct starting procedures are being followed (, 228), consider each of the following points: The engine will not start even though the starter motor operates normally. One of the following may be the cause of the problem: There may not be sufficien ...

Bulb locations
Front Vehicles without daytime running lights or with bulb type daytime running lights Headlight high beam and daytime running lights (if equipped) Headlight low beam (halogen bulb) Fog light (if equipped) Front turn signal/parking and front side marker lights Vehic ...

Trailer towing tips
Your vehicle will handle differently when towing a trailer. Help to avoid an accident, death or serious injury, keep the following in mind when towing: Speed limits for towing a trailer vary by state or province. Do not exceed the posted towing speed limit. Toyota recommends that the ve ...