Toyota Sienna Service Manual: Second brake piston

Reassembly

1. INSTALL FRONT OIL PUMP OIL SEAL (a) Using SST and a hammer, install a new oil seal to the oil pump body. SST 09350-32014 (09351-32140) HINT: The seal end should be flat with the outer edge ...

Disassembly

1. REMOVE 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY (a) Place SST on the return spring and compress the return spring with a press. SST 09387-00060 (b) Using a screwdriver, remove the snap ...

Other materials:

Park / Neutral Position Switch Circuit
DESCRIPTION The fold seat control ECU receives signals from the Park/Neutral position switch and controls the seat stowing and return operations. If the shift lever is in any position other than P the seat cannot be operated. If the ignition switch is in ACC or IG the seat cannot be operate ...

Installation
1. INSTALL VANE PUMP ASSEMBLY (a) Temporarily install the bolt to the vane pump assembly. (b) Install the vane pump assembly. (c) Temporarily install the bolt (B). (d) Using SST, tighten the 2 bolts. SST 09249-63010 Torque:Without SST 43 N*m (439 kgf*cm, 32 ft.*lbf) With SST 29 ...

Rear Speed Sensor RH Circuit
DESCRIPTION Refer to DTCs C0200/31, C0205/32, C1235/35, and C1236/36 (See page BC-17). DTCs C1273/73 to C1278/78 can be deleted when the speed sensor sends a vehicle speed signal or the Test Mode ends. DTCs C1273/73 to C1278/78 are output only in the Test Mode. HINT: DTC C0210/33 ...