Toyota Sienna Service Manual: Tire pressure warning ecu

Disposal

HINT: The tire pressure warning valve and transmitter is powered by a lithium battery. When disposing of the tire pressure warning valve and transmitter, remove the battery and dispose of it corre ...

Removal

NOTICE: Before removing the tire pressure warning ECU, read the registered transmitter IDs of all wheels and write them down to use for re-registration of transmitter IDs (See page TW-20). 1. DIS ...

Other materials:

Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working. 2. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  Disengage the 4 clips and remove the instrument cluster finish panel sub-assembly. ...

Disposal
1. DISPOSE OF SHOCK ABSORBER ASSEMBLY REAR LH (a) Fully extend the shock absorber rod. (b) Using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside the cylinder. CAUTION: When drilling, since the fragments may fly out, work careful ...

Insufficient Coolant Temperature for Closed Loop Fuel Control
DESCRIPTION Refer to DTC P0115 (See page ES-133). MONITOR DESCRIPTION The resistance of the ECT sensor varies in proportion to the actual ECT. The ECM supplies a constant voltage to the sensor and monitors the signal output voltage of the sensor. The signal voltage output varies acc ...