Toyota Sienna Service Manual: Unmatched Encryption Code
DTC B2794 Unmatched Encryption Code
DESCRIPTION
This DTC is output when a key with an incomplete key code is inserted into the ignition key cylinder.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|
B2794 |
Key with incomplete key code inserted | Key |
INSPECTION PROCEDURE
1 RE-REGISTER KEY
- Delete the DTC.
- Re-register the key and insert this key into the ignition key cylinder.
Check that the engine starts with this key.
OK: The engine starts
REPLACE KEY
Transponder Chip Malfunction
DTC B2793 Transponder Chip Malfunction
DESCRIPTION
This DTC is output when a malfunction is found in the key during the key code
registration or the key code
is not registered normally. Replace t ...
Unmatched Key Code
DTC B2795 Unmatched Key Code
DESCRIPTION
This DTC is output when a key with a code that has not been registered in the
ECU is inserted into the
ignition key cylinder.
DTC No.
D ...
Other materials:
Front Clearance Sonar Sensor LH Circuit
DESCRIPTION
An ultrasonic sensor consists of a sensor portion that transmits and receives
ultrasonic waves and a preamplifier
that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and
sends the received
signals to the clearance warning ECU.
WIRING DIAGRAM
INSPECTION PROC ...
TS and CG Terminal Circuit
DESCRIPTION
The Test Mode (signal check) circuit detects trouble in the sensor or switch
signal, which cannot be
detected by the DTC check.
Connecting terminals TS and CG of the DLC3 starts the check.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTR ...
Fuel information
You must only use unleaded gasoline in your vehicle.
Select octane rating 87 (Research Octane Number 91) or higher.
Use of unleaded gasoline with an octane rating lower than 87
may result in engine knocking. Persistent knocking can lead to
engine damage.
At minimum, the gasoline you use s ...
