Toyota Sienna Service Manual: Transponder Chip Malfunction
DTC B2793 Transponder Chip Malfunction
DESCRIPTION
This DTC is output when a malfunction is found in the key during the key code registration or the key code is not registered normally. Replace the key when the key code registration is not performed normally and this DTC is detected.
INSPECTION PROCEDURE
1 CHECK DTC OUTPUT
- Delete the DTC.
- Insert the key into the ignition key cylinder.
- Check that no code is output.
OK: No DTC is output.
2 RE-REGISTER KEY
- Delete the DTC.
- Re-register the key and insert this key into the ignition key cylinder.
Check that the engine starts with the key.
OK: The engine starts
REPLACE KEY
Antenna Coil Open / Short
DTC B2784 Antenna Coil Open / Short
DESCRIPTION
The transponder key coil is built into the transponder key amplifier and
receives a key code signal from
the transponder chip in the key. This sign ...
Unmatched Encryption Code
DTC B2794 Unmatched Encryption Code
DESCRIPTION
This DTC is output when a key with an incomplete key code is inserted into
the ignition key cylinder.
DTC No.
DTC Detection Condi ...
Other materials:
Removal
1. REMOVE ENGINE AND TRANSAXLE
HINT:
(See page EM-26)
2. REMOVE AUTOMATIC TRANSMISSION WITH
TRANSFER
HINT:
(See page AX-164)
3. REMOVE TRANSFER ASSEMBLY
HINT:
(See page TF-8)
4. REMOVE CTR DIFFERENTIAL LOCK SLEEVE
HINT:
(See page TF-13)
5. REMOVE TRANSFER CASE OIL SEAL
(a) Using SS ...
Reassembly
1. INSTALL BACK DOOR STOPPER LOWER
Install the 2 stoppers with the 4 bolts.
Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
2. INSTALL BACK DOOR BASE STOPPER BRACKET
Install the 2 stopper brackets with the 4 bolts.
Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
3. INSTALL BACK DOOR LOCK ASSEMBLY
...
Clock
PARTS LOCATION
On-vehicle inspection
1. INSPECT INTEGRATION CONTROL & PANEL ASSEMBLY
Disconnect the A9 connector.
Measure the voltage according to the value(s) in the
table below.
Standard voltage
Measure the resistance according to the value(s) in
the ...
