Toyota Sienna Service Manual: Engine immobiliser

Security horn assembly

INSPECTION 1. INSPECT SECURITY HORN ASSEMBLY  Check operation of the horn. Standard If the result is not a ...

Engine immobiliser system

PARTS LOCATION SYSTEM DESCRIPTION The engine immobiliser system has been designed to prevent the vehicle from being stolen. This system uses a transponder key ECU that stores the key code of t ...

Other materials:

Terminals of ECU
1. CHECK DRIVER SIDE J/B ASSEMBLY (MULTIPLEX NETWORK BODY ECU)  Disconnect the B6, 1C, 1K and 1L J/B connectors. Measure the voltage and resistance according to the value(s) in the table below. HINT: If the result is not as specified, there may be a malfunction on the w ...

Tire Pressure Warning Light Circuit
DESCRIPTION If the ECU detects trouble, the tire pressure warning light blinks (comes on after blinking for 1 minute) and tire pressure monitor is cancelled at the same time. At this time, the ECU records a DTC in the memory. Connect terminals TC and CG of DLC3 to make the tire pressure war ...

Installation
1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY (a) Install the brake pedal support sub-assembly with the 4 nuts. Torque: 16 N*m (160 kgf*cm, 12 ft.*lbf) (b) Install the clip and clevis pin to the brake pedal lever. (c) Using needle-nose pliers, install the tension spring. (d) Install the ...