Toyota Sienna Service Manual: Vehicle Speed Sensor Malfunction
DTC P0500 Vehicle Speed Sensor Malfunction
DTC P0503 Vehicle Speed Sensor Circuit Malfunction
DESCRIPTION
The cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system.
If DTC P0500 is detected, perform the diagnosis using the inspection procedure for DTC P0500 in the SFI system. The speed signal is converted for use by the cruise control inside the ECM.
Both the SFI system and the cruise control system can set DTC P0500, however the detection conditions of the two systems are different.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|
P0500 |
The vehicle speed signal from the vehicle speed sensor is cut for 0.14 sec. or more while the cruise control is in operation. |
|
|
P0503 |
Momentary interruption and noise malfunction codes are detected when a rapid change of vehicle speed occurs while the cruise control is in operation. |
WIRING DIAGRAM
INSPECTION PROCEDURE
Diagnostic trouble code chart
If a trouble code is indicated during the DTC check, check the
circuit listed for that code in the table below, and proceed to
the applicable page.
CRUISE CONTROL SYSTEM
...
Brake Switch "A" Circuit
DTC P0571 Brake Switch "A" Circuit
DESCRIPTION
When the brake pedal is depressed, the stop light switch sends a signal to
the ECM. When the ECM
receives this signal, it cancels the crui ...
Other materials:
Open in Side Squib LH Circuit
DTC B0116/48 Open in Side Squib LH Circuit
DESCRIPTION
The side squib LH circuit consists of the center airbag sensor assembly and
the front seat side assembly
LH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0116/48 is recorded when an open circuit is ...
Disassembly
1. REMOVE BACK DOOR GARNISH CENTER
Using a clip remover, disengage the 5 clips and
remove the garnish center.
2. REMOVE BACK DOOR SIDE GARNISH LH
Using a clip remover, disengage the 3 clips and
remove the side garnish.
3. REMOVE BACK DOOR SIDE GARNISH RH
Using a clip remove ...
Power seat switch
Inspection
1. INSPECT FRONT POWER SEAT SWITCH
Inspect the driver side power seat switch.
Measure the resistance according to the
value(s) in the table below.
Standard resistance:
Slide switch
Front vertical switch
Lifter switch
Reclining switch
If the res ...
