Toyota Sienna Service Manual: Cruise control system
- Precaution
- System description
- How to proceed with troubleshooting
- Road test
- Problem symptoms table
- Terminals of ECM
- Diagnosis system
- DTC check / clear
- Fail-safe chart
- Data list / active test
- Diagnostic trouble code chart
Cruise control
...
Precaution
1. HANDLING PRECAUTION FOR CRUISE CONTROL
SYSTEM
Turn the cruise control main switch off when not
using the cruise control system.
Be careful as the vehicle speed increases when
...
Other materials:
Removal
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
NOTICE:
Wait for 90 se ...
Removal
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
NOTICE:
Wait for 90 seconds ...
Perform zero point calibration of yaw rate and deceleration sensor (when
using intelligent tester)
(a) Connect the intelligent tester to the DLC3.
(b) Turn the ignition switch to the ON position.
(c) Operate the intelligent tester to erase the codes
(select "RESET MEMORY").
HINT:
Refer to the intelligent tester operator's manual for
further details.
(d) Using the intell ...
