Toyota RAV4 manuals

Toyota Sienna Service Manual: Air conditioning pressure sensor

Toyota Sienna Service Manual / Air conditioning / Air conditioning pressure sensor

ON-VEHICLE INSPECTION

1. INSPECT A/C PRESSURE SENSOR

 INSPECT A/C PRESSURE SENSOR

(a) Install the manifold gauge set.

(b) Disconnect the connector from the A/C pressure sensor.

(c) Connect the three 1.5 V dry cell batteries' positive (+) lead to terminal 3 and the negative (-) lead to terminal 1.

(d) Connect the voltmeter's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1.

(e) Measure the voltage according to the value(s) in the table below.

Standard voltage

If the result is not as specified, replace the A/C pressure sensor.

Evaporator temperature sensor (for rear air conditioning system)
ON-VEHICLE INSPECTION 1. INSPECT REAR A/C EVAPORATOR TEMPERATURE SENSOR (a) Remove the rear evaporator temperature sensor. (b) Disconnect the connector from the rear evaporator temperature s ...

Magnetic clutch relay
ON-VEHICLE INSPECTION 1. INSPECT MAGNETIC CLUTCH RELAY (a) Remove the magnetic clutch relay. (b) Measure the resistance according to the value(s) in the table below. Standard resistance I ...

Other materials:

Steering Angle Sensor Zero Point Malfunction
DTC C1290/66 Steering Angle Sensor Zero Point Malfunction DESCRIPTION The skid control ECU acquires steering angle sensor zero point every time the ignition switch is turned to the ON position and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also sto ...

Check mode procedure
1. CHECK MODE (SIGNAL CHECK): DTC CHECK  Connect the intelligent tester to the DLC3. ) Turn the ignition switch to the ON position. ) Select the "SIGNAL CHECK", and proceed checking using the intelligent tester. NOTICE: Select the "SIGNAL CHECK" from the &q ...

Data list / active test
HINT: By accessing the DATA LIST displayed on the intelligent tester, you can perform such functions as reading the values of switches and sensors without removing any parts. Reading the DATA LIST as the first step in troubleshooting is one method to shorten labor time. 1. DATA LIST FOR CENTER ...

В© 2011-2026 Copyright www.tsienna.net