Toyota Sienna Service Manual: Back door support

Power back door warning buzzer

INSPECTION 1. POWER BACK DOOR WARNING BUZZER Check the resistance of the buzzer. Resistance If the result is not as specified, replace the buzzer. NOTICE: The circuit that causes t ...

Removal

HINT: On the RH side, use the same procedures as on the LH side. 1. REMOVE BACK DOOR STAY SUB-ASSEMBLY LH Remove the 2 bolts and disconnect the stay from the body panel. Using the screwd ...

Other materials:

Installation
1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY  Apply MP grease to the crank arm pivot of the windshield wiper motor assembly.  Install the windshield wiper motor assembly with the 3 bolts to the windshield wiper link assembly. Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 2. INST ...

Audio system operation buttons
“AUDIO” button Display the “Select Audio Source” screen or audio top screen. “SETUP” button Press this button to customize the function settings. “CAR” button Press this button to access the vehicle information. button Press this button to access the Blue ...

Park / Neutral Position Switch Circuit
DESCRIPTION The clearance warning ECU receives the reverse or park position signal from the park / neutral position switch. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT CLEARANCE WARNING ECU Disconnect the C9 connector from the clearance warning ECU.  Measure the voltage ...