Toyota RAV4 manuals

Toyota Sienna Service Manual: Diagnostic trouble code chart

Toyota Sienna Service Manual / Lighting / Lighting system / Diagnostic trouble code chart

1. DTC CHECK

If a malfunction code is displayed during the DTC check , check the suspected area listed for that code in the table below, and proceed to the appropriate page.

DIAGNOSTIC TROUBLE CODE CHART

DTC No.

Detection Item

Suspect Area

B1244

Light Sensor Circuit Malfunction
  1. Automatic light control sensor
  2. Harness or connector
  3. Multiplex network body ECU
Data list / active test
1. DATA LIST HINT: By the DATA LIST displayed by the intelligent tester, you can read the value of the switch, sensor, actuator and so on without removing any part. Reading the DATA LIST as the f ...

Light Sensor Circuit Malfunction
DTC B1244 Light Sensor Circuit Malfunction DESCRIPTION This DTC is output when failure in the light sensor circuit is detected. DTC No. DTC Detection Condition Trouble Area ...

Other materials:

Dtc check / clear
Notice:All the stored dtcs and freeze frame data are erased if: 1) the ecm is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from on to acc or off while in check mode. Before changing modes, always check and make a note of any dt ...

Short to GND in Driver Side Squib Circuit
DTC B0102/11 Short to GND in Driver Side Squib Circuit DESCRIPTION The driver side squib circuit consists of the center airbag sensor assembly, the spiral cable and the steering pad. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B0102/11 is recorded when ...

Installation
1. INSTALL FRONT STABILIZER BAR 2. INSTALL NO. 1 FRONT STABILIZER BAR BUSHING (a) Install the 2 front stabilizer bar bush No.1 to the stabilizer bar front. NOTICE: Install the bushings with the slit facing on the rear side of the vehicle. HINT: Install the bushing to the outer side of th ...

В© 2011-2026 Copyright www.tsienna.net