Toyota Sienna Service Manual: Curtain shield airbag assembly

Disposal

HINT: When scrapping a vehicle equipped with the SRS or disposing of the front passenger airbag assembly, be sure to deploy the airbag first in accordance with the procedure described below. If an ...

On-vehicle inspection

1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check. With the curtain shield airbag assembly installed on the vehicle, pe ...

Other materials:

SRS Warning Light does not Come ON
DESCRIPTION WIRING DIAGRAM INSPECTION PROCEDURE 1 CHECK BATTERY Measure the voltage of the battery. Standard voltage: 11 to 14 V 2 CHECK CONNECTORS Turn the ignition switch to the LOCK position.  Disconnect the negative (-) terminal cable from the battery, and wait for at le ...

Installation
1. INSTALL BRAKE ACTUATOR (a) Install the brake actuator assembly with the 2 nuts. Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 2. INSTALL BRAKE ACTUATOR WITH BRACKET (a) Install the actuator with bracket with the 3 bolts. Torque: 20 N*m (199 kgf*cm, 14 ft.*lbf) NOTICE: Be careful not to dam ...

Air Outlet Damper Control Servo Motor Circuit
DESCRIPTION This circuit turns the servo motor and changes each damper position by receiving the signals from the A/ C amplifier. The air outlet damper servo motor switches the air outlet mode by rotating (normal, reverse) with electrical power from the A/C amplifier. When the AUTO swit ...