Toyota Sienna Service Manual: DSP Error
DTC 63-78 DSP Error
DESCRIPTION
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|
63-78 |
An error occurs during the decode process (MP3 / WMA). |
- |
INSPECTION PROCEDURE
HINT: After the inspection completed, clear the DTCs.
NOTICE:
- This code may be output even if there is no malfunction.
- If this code is output frequently, replace the radio and navigation assembly.
1 CLEAR DTC
- Clear the DTCs.
HINT: These DTCs do not indicate a malfunction.
2 RECHECK DTC
- Recheck for DTCs and check if the same trouble occurs again.
OK: Malfunction disappears
END
High Temperature
DTC 63-47 High Temperature
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
63-47
Sensor detects that CD unit temperature is high (Over
80C).
R ...
Disc cannot be Played/ No Playable Files/ Copyright Protection Error
DTC 63-7D Disc cannot be Played
DTC 63-7E No Playable Files
DTC 63-7F Copyright Protection Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
63-7 ...
Other materials:
The keys
The following keys are provided with the vehicle.
Vehicles without a smart key system
Master keys (black)
Valet key (gray)
Key number plate
Vehicles with a smart key system
Electronic keys
Operating the smart key system
Operating the wireless remote
contr ...
Short to GND in Curtain Shield Squib LH Circuit
DTC B1167/85 Short to GND in Curtain Shield Squib LH Circuit
DESCRIPTION
The curtain shield squib LH circuit consists of the center airbag sensor
assembly and the curtain shield
airbag assembly LH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1167/85 is ...
Terminals of ecu
1. Terminal of ECU
(*1): Models with dynamic laser cruise control
(*2): 2WD model
2. Terminal Inspection
(a) Disconnect the connector and measure the voltage
or resistance on the wire harness side.
HINT:
Voltage cannot be measured with the connector
connected to the skid control ECU ...
