Toyota Sienna Service Manual: Disc cannot be Played/ No Playable Files/ Copyright Protection Error

Toyota Sienna Service Manual / Navigation / Navigation system / Diagnostic trouble code chart / Disc cannot be Played/ No Playable Files/ Copyright Protection Error

DTC 63-7D Disc cannot be Played

DTC 63-7E No Playable Files

DTC 63-7F Copyright Protection Error

DESCRIPTION

DTC No.	DTC Detection Condition	Trouble Area
63-7D	An incompatible MP3 / WMA file is used. Although the file has an extension of ".mp3" or ".wma", the header information cannot be read.	CD Radio and navigation assembly
63-7E	A disc with no music data is used. Playable files are not on the disc (MP3 / WMA).
63-7F	A copy-protected file, which cannot be played, is used.

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 CHANGE DISC

Insert a disc with a playable file and check if the disc can be played correctly.

HINT: For details on playable files and discs, refer to the Owner's Manual.

OK: The disc can be played correctly.

DISC IS FAULTY

DSP Error

DTC 63-78 DSP Error DESCRIPTION DTC No. DTC Detection Condition Trouble Area 63-78 An error occurs during the decode process (MP3 / WMA). - I ...

Noise Occurs

INSPECTION PROCEDURE 1 NOISE CONDITION Check in which direction the noise comes from (front left or right, or rear left or right). Check in which direction the noise comes from. ...

Other materials:

Television camera
COMPONENTS REMOVAL 1. REMOVE BACK DOOR GARNISH CENTER HINT: Back Door: Power Back Door: 2. REMOVE BACK DOOR SIDE GARNISH LH HINT: Back Door: Power Back Door: 3. REMOVE BACK DOOR SIDE GARNISH RH Back Door: Power Back Door: ...

Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE FRONT DOOR SCUFF PLATE LH 3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH (See page IP-6) 5. REMOVE TIRE PRESSURE WARNING RESET SWITCH (a) Disengage the 2 claws and remove t ...

Slip Indicator Light Remains ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN and multiplex communications. The SLIP indicator blinks during VSC and/or TRAC operation. When the system fails, the SLIP indicator comes on to warn the driver. WIRING DIAGRAM INSPECTION PROCEDURE NOTICE: ...