Toyota Sienna Service Manual: Fail-safe chart

Toyota Sienna Service Manual / Cruise control / Cruise control system / Fail-safe chart

HINT: If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition	Auto Cancel Condition	Re-operation Condition
CRUISE main indicator light blinks	There is open or short in stop light switch circuit There is problem with vehicle speed signal There is problem with throttle position sensor and motor	Turn cruise control main switch on again
CRUISE main indicator light blinks	There is problem with input circuit of stop light switch circuit There is problem with cancel circuit	Turn ignition switch off then on again
Cruise control is cancelled (The indicator light remains on)	At the following conditions, the stored vehicle speed is maintained. Vehicle speed is lower than low speed limit (approx. 40 km/h (25 mph)) while running with cruise control on VSC operates	Push cruise control main switch to + (ACCEL)/RES (RESUME)
	Vehicle speed is lower than stored speed by approx. 16 km/h (10 mph) or more	Push cruise control main switch to - (COAST)/ SET

DTC check / clear

1. DTC CHECK Connect the intelligent tester to the DLC3. Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect th ...

Data list / active test

1. READ DATA LIST HINT: Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This ...

Other materials:

Removal
1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working. 3. REMOVE STEERING WHEEL NO.3 COVER LOWER Using a ...

Installation
1. INSTALL ROOF DRIP SIDE FINISH MOULDING When exchanging the clips Remove the tape that remains on the mounting surface of the vehicle body and then clean the surface with white gasoline. Using a heat light, heat up the clip installation surfaces of the vehicle body and moulding. ...

Illumination for Panel Switch does not Come on with Tail Switch ON
INSPECTION PROCEDURE 1 CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE) Enter the "Display Check" mode (Vehicle Signal Check Mode). Check that the display changes between ON and OFF according to the light control switch operation. OK HINT: This display is updated once ...