Toyota Sienna Service Manual: Front stabilizer bar (for 4wd)

Installation

1. INSTALL STABILIZER BAR FRONT 2. INSTALL FRONT STABILIZER BAR BUSH NO.1 (a) Install the front stabilizer bar bush No. 1. HINT: Install the bushing to the outer side of the bushing stopper o ...

Removal

1. REMOVE FRONT WHEELS 2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH HINT: (See page SP-26) 3. REMOVE FRONT STABILIZER LINK ASSEMBLY RH HINT: Remove the RH side by the same procedures as the LH s ...

Other materials:

Installation
1. INSTALL SHIFT LEVER ASSEMBLY (a) Install shift lever assembly to the vehicle with the 4 bolts. Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) NOTICE: Into datum hole of shift lever into datum pin of instrument lower. (b) Connect the 2 connectors to the shift lever assembly. ...

For vehicles equipped with traction control (trac) system
When using a 2-wheel drum tester such as a speedometer tester or chassis dynamometer, etc., or jacking up the front wheels and driving the wheels, always push in the TRAC cut ("TRAC OFF") switch and turn the TRAC system OFF. FOR VEHICLES EQUIPPED WITH TRACTION CONTROL (TRAC) SYS ...

Customize parameters
HINT: The following item can be customized. NOTICE:  After confirming whether the items requested by the customer are applicable or not for customization, perform the customize operation.  Be sure to record the current settings before customizing.  When troubleshooting ...