Toyota Sienna Service Manual: GPS Antenna Error/ GPS Antenna Power Source Error
DTC 58-40 GPS Antenna Error
DTC 58-41 GPS Antenna Power Source Error
DTC 80-40 GPS Antenna Error
DTC 80-41 GPS Antenna Power Source Error
DESCRIPTION
|
DTC No. |
DTC Detection Condition |
Trouble Area |
| 58-40 | GPS antenna error |
|
| 58-41 | Error of the power source to the GPS antenna | |
| 80-40 | GPS antenna error | |
| 80-40 | Error of the power source to the GPS antenna |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.
1 CHECK HARNESS AND CONNECTOR (GPS ANTENNA - RADIO AND NAVIGATION ASSEMBLY)
- Check that the GPS antenna cord is securely connected to the radio and navigation assembly connector.
OK: The cord is securely connected.
2 REPLACE GPS ANTENNA
- Replace the GPS antenna with a normal one and check if the same problem occurs again.
- Clear the DTCs.
- Recheck for DTCs and check if the same trouble occurs again.
OK: Same problem does not occur.
END
GPS Receiver Error
DTC 58-11 GPS Receiver Error
DTC 80-11 GPS Receiver Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
58-11
RTC, ROM, and RAM of the GPS r ...
Map Disc Read Error
DTC 58-42 Map Disc Read Error
DTC 80-42 Map Disc Read Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
58-42
Player error
Scrat ...
Other materials:
On-vehicle inspection
1. CHECK AUTO SLIDE-OPEN / CLOSE FUNCTION
Check that the sliding roof switch can operate the
sliding roof glass as follows while the tilt-up / DOWN
function is not operating.
Standard
HINT:
The sliding roof stops partway when the sliding roof
switch is pushed on either side during AU ...
Transmission Range Sensor Circuit Malfunction
(PRNDL Input)
DESCRIPTION
The park/neutral position switch detects the shift lever position and sends
signals to the ECM.
MONITOR DESCRIPTION
These DTCs indicate a problem with the park/neutral position switch and the
wire harness in the park/
neutral position switch circuit.
The park/neutral po ...
Camshaft Position "B" Actuator Circuit
DESCRIPTION
The Variable Valve Timing (VVT) system includes the ECM, OCV and VVT
controller. The ECM sends a
target duty-cycle control signal to the OCV. This control signal regulates the
oil pressure supplied to the
VVT controller. Camshaft timing control is performed according to engine ...
