Toyota Sienna Service Manual: Installation
1. INSTALL REAR NO. 1 SEAT ASSEMBLY LH
- Place the seat in the cabin.
NOTICE: Be careful not to damage the body.
- Install the seat.
- 7-Passenger RH:
Install the seat belt anchor plate with the bolt.
Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
- Install the headrest.
- When sliding the seat, check that the both sides of the adjuster lock simultaneously.
HINT: Check that the seat adjuster locks.
Reassembly
1. INSTALL NO. 1 SEAT CUSHION FRAME SUBASSEMBLY
LH
Install the seat cushion frame with the bolt.
Torque: Except 7-Passenger RH, M8 bolt
20.6 N*m (210 kgf*cm, 15 ft.*lbf)
M10 bolt
41 ...
Other materials:
How to proceed with
troubleshooting
HINT:
Use the following procedures to troubleshoot the dynamic
laser cruise control system.
*: Use the intelligent tester
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
3 PROBLEM SYMPTOM CONFIRMATION
Result
SYMPTOM SIMULATION
4 INSPECT BATTERY VOLTAGE
Stan ...
Drive information
Items displayed can be switched
by pressing the “DISP” switch.
Current fuel economy
Displays the current rate of fuel consumption.
Use the displayed current fuel consumption as a reference.
Average fuel economy
Displays the average fuel consumption since the function was reset
...
Problem symptoms table
HINT:
Before inspecting the suspected areas listed in the table
below, check the fuse and relay.
Before inspecting the suspected areas listed in the table
below, check for DTCs.
Methods used to verify the cause of the problem are listed
in order of probability in the ...
