Toyota Sienna Service Manual: Rear no. 1 Seat assembly (for Center Seat)

Installation

1. INSTALL REAR NO. 1 SEAT ASSEMBLY LH  Place the seat in the cabin. NOTICE: Be careful not to damage the body.  Install the seat.  7-Passenger RH: Install the seat belt ...

Components

REMOVAL 1. REMOVE REAR NO. 1 SEAT ASSEMBLY CENTER  Remove the headrest.  Remove the bolt and seat belt anchor plate.  Remove the rear seat. ...

Other materials:

Installation
1. INSTALL TRANSMISSION WIRE (a) Coat the O-ring of the transmission wire connector with ATF and install it. (b) Install the transmission wire with the bolt. Torque: 5.4 N*m (55 kgf*cm, 48 ft.*lbf) 2. CONNECT TRANSMISSION WIRE (a) Coat the O-ring of the ATF temperature sensor with ...

Removal
1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY  Push the right side wall and then push the left wall to release the stoppers. Pull the glove compartment door sub-assembly rearward to remove it. 2. REMOVE NO. 2 INSTRUMENT PANEL BOX  Disengage the 2 claws and 4 cl ...

Short in Rear Curtain Shield Squib RH Circuit
DTC B1630/83 Short in Rear Curtain Shield Squib RH Circuit DESCRIPTION The rear curtain shield squib RH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly RH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1630/83 ...