Toyota Sienna Service Manual: Navigation receiver

Television Display Power Source Circuit

DESCRIPTION This is the power source circuit to operate the television display assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT TELEVISION DISPLAY ASSEMBLY Disconnect the connec ...

Removal

1. REMOVE INSTRUMENT CLUSTER NO.1 FINISH PANEL CENTER 2. REMOVE INSTRUMENT CLUSTER NO.2 FINISH PANEL CENTER 3. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH 4. REMOVE NAVIGATION RECEIVER ASSEMBLY ...

Other materials:

Disposal
1. DISPOSE OF SHOCK ABSORBER ASSEMBLY FRONT LH HINT: Dispose the RH side by the same procedures as the LH side. (a) Fully extend the shock absorber rod. (b) Using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside. CAUTION: When dril ...

Eject Error/ Elevator Error/ Clamp Error
DTC 44-45 Eject Error DTC 44-51 Elevator Error DTC 44-52 Clamp Error DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 44-45 Disc cannot be ejected. Television display assembly 44-51 Mechanical error occurs during elevator operation. ...

SRS Warning Light does not Come ON
DESCRIPTION WIRING DIAGRAM INSPECTION PROCEDURE 1 CHECK BATTERY Measure the voltage of the battery. Standard voltage: 11 to 14 V CHECK AND REPLACE BATTERY OR CHARGING SYSTEM 2 CHECK CONNECTORS Turn the ignition switch to the LOCK position.  Disconnect the negative (-) term ...