Toyota Sienna Service Manual: Power point socket (for Rear Side)

Installation

1. INSTALL POWER POINT SOCKET ASSEMBLY  Engage the 2 claws to install the power point socket assembly. 2. INSTALL INSTRUMENT CLUSTER CENTER LOWER FINISH PANEL SUB-ASSEMBLY 3. INSTA ...

Removal

1. REMOVE REAR DOOR SCUFF PLATE LH 2. REMOVE REAR DOOR WEATHERSTRIP LH 3. REMOVE BACK DOOR WEATHERSTRIP 4. REMOVE BACK DOOR SCUFF PLATE 5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY LH 6. REMOVE PO ...

Other materials:

Removal
1. DRAIN BRAKE FLUID NOTICE: Wash brake fluid off immediately if it adheres to any painted surface. 2. DISCONNECT BATTERY NEGATIVE TERMINAL 3. REMOVE AIR CLEANER ASSEMBLY WITH HOSE 4. REMOVE BRAKE ACTUATOR WITH BRACKET (a) Release the latch of the brake actuator connector to disconnect t ...

Removal
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY HINT:  Refer to the instructions for disassembly of the front seat assembly (for flat type).  Refer to the instructions for disassembly of the front seat assembly (for manual seat). Refer to the instructions for disassembly of the fro ...

Adjustment
HINT: On the RH side, use the same procedures as on the LH side. 1. INSPECT SLIDE DOOR PANEL SUB-ASSEMBLY LH Check that the clearance is within the standard range. Standard 2. ADJUST SLIDE DOOR PANEL SUB-ASSEMBLY LH Using the SST, horizontally and vertically adjust the do ...