Toyota Sienna Service Manual: Other system
- Clock
- Cigarette lighter
- Power outlet socket
- Power point socket (for Front Side)
- Power point socket (for Rear Side)
Installation
1. INSTALL OCCUPANT CLASSIFICATION ECU
Check that the ignition switch is off.
Check that the negative battery (-) terminal is
disconnected.
CAUTION:
After disconnecting the ...
Clock
PARTS LOCATION
On-vehicle inspection
1. INSPECT INTEGRATION CONTROL & PANEL ASSEMBLY
Disconnect the A9 connector.
Measure the voltage according to the value(s) in the
...
Other materials:
Gyro Error
DTC 58-10 Gyro Error
DTC 80-10 Gyro Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
58-10
Ground short, power supply short, or open circuit in the
gyro signal
Gyro sensor
Radio and navigation assembly
80-10
...
Check that initialization has been completed
(a) Confirm that the data of tire pressure of all tires are
displayed on the intelligent tester screen.
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
TIREPRESS1
ID1 tire inflation pressure (Absolute
pressure) /
min.: 100 kPa (1 kgf/cm2, 14 ...
Using a flatbed truck
If you use chains or cables to tie
down your vehicle, the angles
shaded in black must be 45.
Do not overly tighten the tie
downs or the vehicle may be damaged.
WARNINGObserve the following precautions.
Failure to do so may result in death or serious injury.
When tow ...
