Toyota Sienna Service Manual: Precaution

Toyota Sienna Service Manual / Engine / 2Gr-fe engine control system / Sfi system / Precaution

1. INITIALIZATION

NOTICE:

Perform RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (See page AX-16).
Perform REGISTRATION (VIN registration) when replacing the ECM (See page ES-15).

HINT:

Initialization cannot be completed by only removing the battery.

2. FOR USING INTELLIGENT TESTER

CAUTION:

Observe the following items for safety reasons:

Before using the tester, read the instruction manual.
Prevent the tester cable from being caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
When driving the vehicle for testing purposes using the tester, two persons are required. One is for driving the vehicle, and the other operates the tester.

3. FOR USING BATTERY DURING INSPECTION

(a) While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

4. COOLING FAN SYSTEM

NOTICE:

When the ignition switch is turned off and the engine temperature is high, the cooling fans may operate for approximately 3 minutes.
After turning the ignition switch off, keep hands and objects away from the fans when they are operating.

HINT:

If all of the following are met for a certain period of time during a few minute period immediately before the engine is stopped, the electric fans will continue to operate for 3 minutes after the engine is stopped. This is performed to ensure restartability and stabilize idle speed.

The intelligent tester indicates a very high coolant temperature.
The intelligent tester indicates a high outside air temperature.
The vehicle has been driven under high load (driving on an uphill or equivalent).

The following sensors are used for this control:

Coolant temperature sensor
Outside air temperature sensor
MAF sensor
Vehicle speed sensors

Sfi system

...

Definition of terms

Terms Definitions Monitor Description Description of what ECM monitors and how to detect malfunctions (monitoring purpose and details). Related DTCs A gro ...

Other materials:

Parking Brake Switch Circuit
DESCRIPTION This circuit is from the parking brake switch to the radio and navigation assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 CHECK BRAKE WARNING LIGHT Check that the brake warning light comes on when the parking brake is applied and goes off when it is released. OK: The ...

Fuel tank
Components REMOVAL 1. DISCHARGE FUEL SYSTEM PRESSURE (See page FU-1) 2. REMOVE CHARCOAL CANISTER PROTECTOR (See page FU-30) 3. REMOVE REAR FLOOR NO. 2 CROSSMEMBER BRACE LH (a) Remove the 2 bolts and the rear floor No. 2 crossmember brace LH. 4. REMOVE FUEL TANK FILLER HOSE COVER ...

Selecting trailer ball
Use the correct trailer ball for your application. Trailer ball load rating Matches or exceeds the gross trailer weight rating of the trailer. Ball diameter Matches the size of the trailer coupler. Most couplers are stamped with the required trailer ball size. Shank len ...