Toyota Sienna Service Manual: Problem symptoms table

Toyota Sienna Service Manual / Seat / Rear no. 2 Seat assembly (w/ Power Stowing Function) / Problem symptoms table

HINT:

Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspect Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed.
Replace parts as necessary.
Inspect the fuse and relays related to the system before inspecting the suspected areas below.

POWER REAR NO. 2 SEAT with STOWING FUNCTION

Symptom	Symptom Suspected area
No functions operate.	Power source circuit Fold seat control ECU
The folding-down function does not operate.	Park/Neutral position switch circuit Back door courtesy switch circuit Lock switch circuit Reclining motor circuit Fold seat switch circuit Folding motor circuit Folding motor Fold seat control ECU
The return function does not operate.	Park/Neutral position switch circuit Back door courtesy switch circuit Reclining motor circuit Folding motor circuit Fold seat switch circuit Release actuator circuit Folding motor Release actuator Fold seat control ECU
The stowing function does not operate.	Park/Neutral position switch circuit Back door courtesy switch circuit Reclining motor circuit Folding motor circuit Fold seat switch circuit Fold lock switch circuit Folding motor Fold seat control ECU
The reclining function does not operate.	Lock switch circuit Reclining motor circuit Rear power seat switch circuit Fold seat control ECU
The indicator does not come on or blink.	Indicator circuit Fold seat control ECU

Initialization

HINT: The seatback position is initialized at the factory before shipment, so initialization is not normally required. There is an initialization function for cases when reinitializati ...

Terminals of ECU

1. FOLD SEAT CONTROL ECU LH Disconnect the fold seat control ECU connectors. Measure the voltage and resistance of the wire harness side connectors. If the result is not as specifie ...

Other materials:

Control Module Performance
DESCRIPTION The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standards, the ECM will illuminate the MIL and set a DTC immediately. The ECM also monitors the cru ...

Transfer oil
ON-VEHICLE INSPECTION 1. INSPECT TRANSFER OIL (a) Remove the No. 1 plug and gasket. (b) Check the oil level is within 0 - 5 mm (0 - 0.20 in.) below the lowest end of the hole for No. 1 plug. NOTICE: When changing oil, recheck the oil level after driving. Excessively large or small ...

DVD Error/ Excess Current/ Tray Insertion / Ejection Error
DTC 44-44 DVD Error DTC 44-48 Excess Current DTC 44-50 Tray Insertion / Ejection Error DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 44-44 Operation error in the DVD mechanism. Television display assembly 44-48 Excess current is ...