Toyota Sienna Service Manual: Sound Quality is Bad Only when CD is Played (Volume is Too Low)
INSPECTION PROCEDURE
1 REPLACE CD WITH ANOTHER AND RECHECK
- Replace the CD with another one and recheck.
- Check if the problem recurs using another CD.
OK: Malfunction disappears.
END
No Sound can be Heard from Speakers
INSPECTION PROCEDURE
1 CHECK RADIO RECEIVER
Check radio receiver setting.
Check that the volume is not set to "0".
Check that "MUTE" is off.
OK:
The vo ...
CD cannot be Ejected
INSPECTION PROCEDURE
1 PRESS "EJECT" AND CHECK OPERATION
Press the CD EJECT switch of the radio receiver for 2
seconds or more and check that the CD is ejected.
OK:
CD is ejected
...
Other materials:
Camshaft Position Sensor "A" Circuit
DESCRIPTION
The intake camshaft's Variable Valve Timing (VVT) sensor (G signal) consists
of a magnet and MRE
(Magneto Resistance Element).
The VVT camshaft drive gear has a sensor plate with 3 teeth on its outer
circumference. When the gear
rotates, changes occur in the air gaps betwee ...
DTC check / clear
1. DTC CHECK
HINT:
When DTC B1150/23 is detected as a result of
troubleshooting for "Airbag System", perform
troubleshooting for the Occupant Classification System.
Check the DTCs.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to t ...
Installation
1. INSTALL FRONT SEAT ASSEMBLY LH
Place the seat assembly in the cabin.
NOTICE:
Be careful not to damage the body.
Connect the connectors under the seat assembly.
Tighten the 2 bolts on the front side of the seat
assembly.
Torque: 37 N*m (375 kgf*cm, 27 ft.*lb ...
