Toyota Sienna Service Manual: Tire pressure warning receiver (w/ antenna)

TC and CG Terminal Circuit

DESCRIPTION DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by blinks of the tire pressure warning light. WIRING DIAGRAM HINT: When eac ...

Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE ROOF HEADLINING ASSEMBLY HINT: Refer to the instructions for REMOVAL of the ROOF HEADLINING (See page IR-6). 3. REMOVE TIRE PRESSURE ...

Other materials:

For manual air conditioning system
ON-VEHICLE INSPECTION 1. INSPECT AIR INLET CONTROL SERVO MOTOR (a) Remove the air inlet control servo motor. (b) Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 1, then check that the lever turns to "RECIRCULATION" side smoothly. ...

How to proceed with troubleshooting
HINT:  Use the following procedures to troubleshoot the cruise control system.  *: Use the intelligent tester. 1 VEHICLE BROUGHT TO WORKSHOP 2 PROBLEM SYMPTOM CONFIRMATION 3 CHECK MULTIPLEX COMMUNICATION SYSTEM* Refer to HOW TO PROCEED WITH TROUBLESHOOTING.  Check fo ...

Installation
1. INSTALL SLIDE DOOR ROLLER ASSEMBLY UPPER Apply MP grease to the rotating areas of the roller. Install the roller with the 2 bolts. Torque: 13 N*m (130 kgf*cm, 10 ft.*lbf) 2. INSTALL SLIDE DOOR HINGE ASSEMBLY CENTER LH Apply MP grease to the rotating areas of the hinge. In ...