Toyota Sienna Service Manual: Brake actuator (w/o vsc)

On-vehicle inspection

1. CONNECT INTELLIGENT TESTER (a) Connect the intelligent tester to the DLC3. (b) Start the engine and run at idle. (c) Select the ACTIVE TEST mode on the intelligent tester. HINT: Pleas ...

Other materials:

Half Connection in Center Airbag Sensor Assembly Connectors
DTC B1135/24 Half Connection in Center Airbag Sensor Assembly Connectors DESCRIPTION The center airbag sensor assembly connector has a mechanism that electrically detects half connection. The center airbag sensor assembly monitors the voltage applied to the disconnection detection pins and ...

Heated oxygen sensor (for 2wd)
Components Removal 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the nagative (-) battery terminal to prevent airbag and seat belt pretensioner activation. 2. REMOVE HEATED OXYGEN SENSOR (for Bank ...

Installation
1. INSTALL COMBINATION METER ASSEMBLY  Connect the connectors.  Install the combination meter assembly with the 4 screws. 2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  Install the instrument cluster finish panel subassembly with the 4 clips. 3. C ...