Toyota Sienna Service Manual: Cellular Phone cannot Send / Receive
INSPECTION PROCEDURE
1 CHECK BLUETOOTH SETTINGS
- Check if the Bluetooth settings are correct.
OK: Bluetooth settings are correct.
2 CHECK CELLULAR PHONE
- Check if the cellular phone is Bluetooth compatible.
HINT: Some versions of Bluetooth compatible cellular phones may not function.
OK: Phone is Bluetooth compatible.
3 CHECK SETTINGS
- Check if the cellular phone functions.
HINT: The cellular phone is unable to call under any of the following conditions.
- The cellular phone is locked.
- The directory is being transferred.
- The line is crossed.
- Transmission is regulated.
- The power is off.
- The cellular phone is not connected to Bluetooth ("BT" is displayed while connected).
OK: None of the above conditions exist
4 CHECK CELLULAR PHONE
- Check if the cellular phone can make a call.
HINT: When the battery is low, calls cannot be made or received.
OK: Cellular phone can make a call.
5 CHECK RECEPTION
- Set the cellular phone so that it can receive calls.
- Place the cellular phone close to the radio and navigation assembly.
- Check if the cellular phone has reception according to the radio and navigation assembly.
OK: Cellular phone has reception.
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Cellular Phone Registration Failure, Phone Directory Transfer Failure
INSPECTION PROCEDURE
1 CHECK CURRENT CONDITIONS
Proceed to the next step according to the table below.
RESULT
2 CHECK USING ANOTHER CELLULAR PHONE
Check if the system functions using an ...
Cannot Call in a Certain Place
INSPECTION PROCEDURE
1 CHECK SURROUNDING CONDITIONS
Check if the cellular phone can make calls in a certain
place.
OK:
It can make calls
2 CHECK RECEPTION
Enter the "Informati ...
Other materials:
Removal
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 s ...
Removal
1. REMOVE INSTRUMENT CLUSTER CENTER NO. 1 FINISH PANEL
2. REMOVE INSTRUMENT CLUSTER CENTER NO. 2 FINISH PANEL
3. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH
4. REMOVE RADIO RECEIVER
Remove the 4 screws.
Disconnect the connectors and remove the radio
receiver with bracke ...
Mute Signal Circuit between Radio Receiver and Stereo Component
Amplifier
DESCRIPTION
This circuit sends a signal to the stereo component amplifier to mute noise.
Because of that, the noise
produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when
changing the sound source.
If there is a short i ...
