Toyota Sienna Service Manual: Cellular Phone Registration Failure, Phone Directory Transfer Failure
INSPECTION PROCEDURE
1 CHECK CURRENT CONDITIONS
- Proceed to the next step according to the table below.
RESULT
2 CHECK USING ANOTHER CELLULAR PHONE
- Check if the system functions using another Bluetooth compatible cellular phone.
HINT:
- Confirm that either the same or a different version of another Bluetooth compatible cellular phone complies with the system.
- Depending on the version, some Bluetooth compatible cellular phones cannot be used.
OK: The system functions.
USE A BLUETOOTH COMPATIBLE CELLULAR PHONE
3 CHECK USING ANOTHER BLUETOOTH COMPATIBLE VEHICLE
- Register the cellular phone with another vehicle and check if the system functions normally.
HINT: Depending on the version, some Bluetooth compatible cellular phones cannot be used.
OK: The system functions
USE A BLUETOOTH COMPATIBLE CELLULAR PHONE
4 CHECK CELLULAR PHONE
- Check if the cellular phone is Bluetooth compatible.
HINT: Some versions of Bluetooth compatible cellular phones may not function.
OK: The phone is Bluetooth compatible.
5 CHECK CELLULAR PHONE
- Check if a call can be made from the cellular phone.
HINT: When the battery is low, registration or directory transfer cannot be done.
OK: A call can be made from the cellular phone.
REPLACE RADIO AND NAVIGATION ASSEMBLY
Voice is not Recognized
INSPECTION PROCEDURE
1 CHECK NAVIGATION SETTINGS
Enter the "Menu" screen by pressing the "MENU" switch.
Select "Setup
Check that "Voice Recogni ...
Cellular Phone cannot Send / Receive
INSPECTION PROCEDURE
1 CHECK BLUETOOTH SETTINGS
Check if the Bluetooth settings are correct.
OK:
Bluetooth settings are correct.
2 CHECK CELLULAR PHONE
Check if the cellular phone is Blu ...
Other materials:
Cup holders
Front
Press in and release the front cup
holder.
Console box type A
(if equipped)
Console box type B
(if equipped)
Pull the lid down.
Console box type C
(if equipped)
Second seat (if equipped)
Removing the second center seat.
Rear
...
TRAC OFF Indicator Light does not Come ON
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN and
multiplex communications.
When the traction OFF switch is turned on, the TRAC OFF indicator light will
come on (for 2WD model).
WIRING DIAGRAM
Refer to TRAC OFF Indicator Light Remains ON (See page BC-157).
...
Removal
1. DISCHARGE FUEL SYSTEM PRESSURE
HINT:
See page FU-1.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
3. REMOVE NO. 1 ENGINE UNDER COVER
4. DRAIN ENGINE COOLANT (See page CO-6)
5. REMOVE FRONT WIPER ARM HEAD CAP (See page
WW-4)
6. REMOVE FRONT WIPER ARM RH (See page WW-4)
7. REMOVE FRO ...
