Toyota Sienna Service Manual: Diagnostic trouble code chart
If a malfunction code is displayed during the DTC check, check the circuit listed for that code in the table below.
(Proceed to the page given for that circuit.)
POWER SLIDE DOOR SYSTEM
|
DTC No. |
DTC No. Detection Item |
Trouble Area |
|
B2223 |
Power Slide Door Pulse Sensor Malfunction on Rear Right Door |
|
|
B2224 |
Power Slide Door Pulse Sensor Malfunction on Rear Left Door |
|
- Power Slide Door Pulse Sensor Malfunction on Rear Right Door
- Power Slide Door Pulse Sensor Malfunction on Rear Left Door
- Power Slide Door LH does not Operate When Satellite Switch is Pressed
- Inspection procedure
- Power Slide Door RH does not Operate When Satellite Switch is Pressed
Data list / active test
1. DATA LIST
HINT:
Using the DATA LIST displayed on the intelligent tester,
you can read the value of the switch, sensor, actuator,
etc. without parts removal. Reading the DATA LIST as
the first ...
Power Slide Door Pulse Sensor Malfunction on
Rear Right Door
DTC B2223 Power Slide Door Pulse Sensor Malfunction on
Rear Right Door
DESCRIPTION
A pulse sensor is built into slide door RH for jam and foreign
object detection and for slide door pos ...
Other materials:
Door control switch
INSPECTION
1. INSPECT DOOR CONTROL SWITCH ASSEMBLY
Measure the resistance according to the value(s) in
the table below.
Standard resistance
HINT:
If the result is not as specified, replace the switch. ...
Disassembly
1. REMOVE REAR NO. 2 SEAT COVER BEZEL
Remove the 5 screws.
Disengage the 5 claws and remove the rear No. 2
seat cover bezel.
2. REMOVE REAR SEAT RECLINING COVER LH
Remove the 2 screws.
Disengage the claw and remove the rear seat
reclining cover LH.
...
Reassembly
1. APPLY HIGH TEMPERATURE GREASE
(a) Apply the high temperature grease to the surface on
which the shoe and backing plate attach.
2. INSTALL PARKING BRAKE SHOE LEVER LH
(a) Install the shoe lever and shim to the rear shoe with
a new C-washer.
(b) Using a feeler gauge, measure the clearance.
...
