Toyota Sienna Service Manual: DSP Error
DTC 44-78 DSP Error
DESCRIPTION
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|
44-78 |
An error occurs during the decode process (MP3 / WMA). |
- |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.
NOTICE:
- This code may be output even if there is no malfunction.
- If this code is output frequently, replace the television display assembly.
1 CLEAR DTC
- Clear the DTCs
2 RECHECK DTC
- Recheck for DTCs and check if the same trouble occurs again.
OK: Malfunction disappears
END
High Temperature
DTC 44-47 High Temperature
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
44-47
Sensor detects that DVD unit temperature is high (Over
80C).
...
Disc cannot be Played/ No Playable Files/ Copyright Protection Error
DTC 44-7D Disc cannot be Played
DTC 44-7E No Playable Files
DTC 44-7F Copyright Protection Error
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
44-7D
...
Other materials:
Check for intermittent problems
1. CHECK FOR INTERMITTENT PROBLEMS
HINT:
For use of the intelligent tester only:
Inspect the vehicle's ECM using check mode.
Intermittent problems are easier to detect with an
intelligent tester when the ECM is in check mode. In
check mode, the ECM uses 1 trip detection logic, which
is more ...
Removal
1. REMOVE FRONT WHEELS
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug, gasket and drain ATF.
(b) Install a new gasket and the drain plug.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
4. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
HINT:
(See page DS-6)
...
Disposal
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
When scrapping a vehicle equipped with the SRS or
disposing of the front seat side airbag assembly, be sure to
deploy the airbag first in accordance with the proc ...
