Toyota Sienna Service Manual: High Temperature
DTC 44-47 High Temperature
DESCRIPTION
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|
44-47 |
Sensor detects that DVD unit temperature is high (Over 80C). | Television display assembly |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.
1 CHECK TELEVISION DISPLAY ASSEMBLY
- Park the vehicle in a cool place.
- Check that the temperature of the television display assembly has become sufficiently low, and start the engine. Check that the malfunction disappears.
OK: Malfunction disappears.
END
Scratched / Reversed Disc
DTC 44-46 Scratched / Reversed Disc
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
44-46
Scratches or dirt is found on DVD surface or DVD is set
...
DSP Error
DTC 44-78 DSP Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
44-78
An error occurs during the decode process (MP3 /
WMA).
-
I ...
Other materials:
Short in Rear Curtain Shield Squib LH Circuit
DTC B1635/87 Short in Rear Curtain Shield Squib LH Circuit
DESCRIPTION
The rear curtain shield squib LH circuit consists of the center airbag sensor
assembly and the curtain
shield airbag assembly LH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1635/87 ...
Fuel Pump Control Circuit
DESCRIPTION
The FUEL PUMP relay switches the fuel pump speed according to the engine
conditions. The fuel pump
operates when the ECM receives the starter-operating signal (STA) and
crankshaft-rotating signal (NE).
The FUEL PUMP relay is turned ON while the engine is idling or operating at l ...
Perform zero point calibration of yaw rate and deceleration sensor (when
using sst check wire)
NOTICE:
While obtaining the zero point, do not vibrate the
vehicle by tilting, moving or shaking it and keep it
in a stationary condition. (Do not turn the ignition
switch to the ON position.)
Be sure to do this on a level surface (with an
inclination of less than 1 %).
(a) Proc ...
