Toyota Sienna Service Manual: Eject Error/ Elevator Error/ Clamp Error
DTC 63-45 Eject Error
DTC 63-51 Elevator Error
DTC 63-52 Clamp Error
DESCRIPTION
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|
63-45 |
Magazine cannot be ejected. | Radio and navigation assembly |
|
63-51 |
Mechanical error occurs during elevator operation. | |
|
63-52 |
Error occurs in CD changer clamp. |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.
1 CHECK RADIO AND NAVIGATION ASSEMBLY
- Check if a disc can be changed, inserted, or ejected normally.
OK: Malfunction disappears.
END
CD Abnormal/ Excess Current/ Tray Insertion / Ejection Error
DTC 63-44 CD Abnormal
DTC 63-48 Excess Current
DTC 63-50 Tray Insertion / Ejection Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
63-44
Operati ...
Scratched / Reversed Disc
63-46 Scratched / Reversed Disc
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
63-46
Scratches or dirt is found on CD surface or CD is set
upsid ...
Other materials:
DTC check / clear
1. CHECK DTC (USING INTELLIGENT TESTER)
Checking DTCs.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Read DTCs by following the prompts on the
tester screen.
HINT:
Refer to the intelligent tester operator's manual
for further deta ...
Installation
1. INSTALL REAR DRIVE SHAFT ASSEMBLY LH
(a) Install the drive shaft to the axle carrier.
NOTICE:
Be careful not to damage the boot and ABS
speed sensor rotor to the drive shaft and oil seal
of the axle hub bearing.
(b) Align the matchmarks and connect the drive shaft to
the side gear shaf ...
Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to
prevent the airbag working.
2. REMOVE FRONT SEAT ASSEMBLY
HINT:
Refer to the instructions for removal of the front seat
assembly (for flat type).
Refer to the in ...
