Toyota Sienna Service Manual: Front passenger airbag assembly

Installation

1. INSTALL SPIRAL CABLE  Check that the front wheels are facing straight ahead.  Set the turn signal switch to the neutral position. NOTICE: If it is not in the neutral pos ...

On-vehicle inspection

1. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check.  With the front passenger airbag assembly installed on the veh ...

Other materials:

Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter
DESCRIPTION This circuit is necessary for the ASL (Auto Sound Leveliser) built into the radio receiver. Speed signals are received from the combination meter and used for the ASL. The ASL function automatically adjusts the sound data in order to enable hearing the clear audio sound even ...

Installation
1. INSTALL ROOF DRIP SIDE FINISH MOULDING When exchanging the clips Remove the tape that remains on the mounting surface of the vehicle body and then clean the surface with white gasoline. Using a heat light, heat up the clip installation surfaces of the vehicle body and moulding. ...

Open in Front Pretensioner Squib RH Circuit
DTC B0131/64 Open in Front Pretensioner Squib RH Circuit DESCRIPTION The front pretensioner squib RH circuit consists of the center airbag sensor assembly and the front seat outer belt assembly RH. This circuit instructs the SRS to deploy when deployment conditions are met. DTC B0131/64 i ...