Toyota Sienna Service Manual: High Temperature
DTC 62-47 High Temperature
DTC 63-47 High Temperature
DESCRIPTION
|
DTC No. |
DTC Detecting Condition |
Trouble Area |
|
62-47 |
Sensor detects that CD unit temperature is high. (Over 80C) | Radio receiver |
|
63-47 |
Sensor detects that CD unit temperature is high. (Over 80C) |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.
1 CHECK RADIO RECEIVER
- Park the vehicle in a cool place.
- Check that the temperature of the radio receiver becomes sufficiently low, and start the engine. Check that the malfunction disappears.
OK: Malfunction disappears.
END
Scratched / Reversed Disc
DTC 62-46 Scratched / Reversed Disc
DTC 63-46 Scratched / Reversed Disc
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
62-46
Scratches or dirt is ...
DSP Error/ DSP Error
DTC 62-78 DSP Error
DTC 63-78 DSP Error
DESCRIPTION
INSPECTION PROCEDURE
HINT:
After the inspection is completed, clear the DTCs.
NOTICE:
These codes may be output even if there is ...
Other materials:
Taillight Relay Circuit
DESCRIPTION
The Multiplex network body ECU controls TAIL relay when signal is received
from headlight dimmer
switch assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER
Connect the intelligent tester to DLC3.
Turn the ignition switch ON and ...
For driver side
ON-VEHICLE INSPECTION
1. INSPECT AIR MIX CONTROL SERVO MOTOR
(a) Remove the air mix control servo motor.
(b) Connect the positive (+) lead from the battery to
terminal 4 and negative (-) lead to terminal 5, then
check that the lever turns to "COOL" side smoothly.
(c) Connect ...
How to use this manual
GENERAL INFORMATION
1. GENERAL DESCRIPTION
(a) This manual is written in accordance with SAE J2008.
(b) Repair operations can be separated mainly in the following 3 processes:
(1) Diagnosis
(2) Removing / Install ...
