Toyota Sienna Service Manual: Installation
1. INSTALL FUEL TANK ASSEMBLY (See page FU-44)V 2. INSPECT FOR FUEL LEAK (See page FU-7) 3. INSTALL FUEL TANK FILLER HOSE COVER (See page FU-45) 4. INSTALL REAR FLOOR NO. 2 CROSSMEMBER BRACE LH (See page FU-46) 5. INSTALL CHARCOAL CANISTER PROTECTOR
(a) Install the 6bots and the charcoal canister protector.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
Reassembly
1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
(a) Apply a light coat of gasoline or spindle oil to the 2
new O-rings, and install it to the fuel pressure
regulator.
(b) Apply a light coat of g ...
Fuel pump resistor
Components
REMOVAL
1. REMOVE FUEL PUMP RESISTOR
(a) Disconnect the connector.
(b) Remove the nut and fuel pump resistor.
INSPECTION
1. INSPECT FUEL PUMP RESISTOR
(a) Inspect fuel ...
Other materials:
Rear Room Temperature Sensor Circuit
DESCRIPTION
This sensor detects the rear cabin temperature that is used as the basis for
temperature control and
sends a signal to the A/C amplifier.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 READ VALUE OF INTELLIGENT TESTER
(a) Connect the intelligent tester to the DLC3.
(b) Turn the ign ...
Disassembly
1. REMOVE NO. 1ULTRASONIC SENSOR RETAINER
(w/ Clearance Sonar System) (See page PM-19)
2. REMOVE NO. 1 ULTRASONIC SENSOR (w/
Clearance Sonar System) (See page PM-19)
3. REMOVE REAR BUMPER ENERGY ABSORBER
4. REMOVE REAR BUMPER BAR PLATE
Remove the 4 clips and the rear bumper bar plate.
5. ...
On-vehicle inspection
1. CHECK POWER SEAT FUNCTION
Check the basic functions.
Operate the power seat switches and check the
following seat functions:
Sliding
Reclining
Front vertical (Driver side seat only)
Lifter (Driver side seat only)
Lumbar suppo ...
