Toyota Sienna Service Manual: Outer rear view mirror

Inner rear view mirror

COMPONENTS REMOVAL 1. REMOVE INNER REAR VIEW MIRROR ASSEMBLY  w/ EC mirror: Remove the inner rear view mirror cover.  w/ EC mirror: Disconnect the connector.  Remove ...

Removal

HINT: On the RH side, use the same procedures as on the LH side. 1. REMOVE FRONT DOOR SERVICE HOLE COVER LH  Remove the front lower frame bracket garnish LH.  Remove the front door i ...

Other materials:

TRAC OFF Indicator Light does not Come ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN and multiplex communications. When the traction OFF switch is turned on, the TRAC OFF indicator light will come on (for 2WD model). WIRING DIAGRAM Refer to TRAC OFF Indicator Light Remains ON (See page BC-157). ...

Data list / active test
1. DATA LIST HINT: Using the DATA LIST displayed on the intelligent tester, you can read the value of the switch, sensor, actuator, etc. without parts removal. Reading the DATA LIST as the first step of troubleshooting is one way to shorten the labor time.  Connect the intelligent tes ...

How to proceed with troubleshooting
HINT:  Use this procedure to troubleshoot the engine immobiliser system.  The intelligent tester should be used in steps 4, 5 and 7. 1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK 3 CRANK ENGINE FOR MORE THAN 10 SECONDS 4 CHECK FOR DTC C ...