Toyota Sienna Service Manual: Mirror
- Power mirror control system (w/ Memory)
- Parts location
- System description
- How to proceed with troubleshooting
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- Data list / active test
- On-vehicle inspection
- Power mirror control system (w/o Memory)
- Inner rear view mirror
- Outer rear view mirror
- Outer mirror switch
Defogger relay
ON-VEHICLE INSPECTION
1. INSPECT DEFOGGER RELAY
Inspect the resistance.
Standard resistance
If the result is not as specified, replace the relay. ...
Other materials:
If your vehicle overheats
The following may indicate that your vehicle is overheating.
The needle of the engine coolant temperature gauge
enters the red zone or a loss of engine power is experienced. (For
example, the vehicle speed does not increase.)
The warning message indicating overheats is shown on the
mult ...
Camshaft Position "B" - Timing Over-Advanced
DTC P0014 Camshaft Position "B" - Timing Over-Advanced
or System Performance (Bank 1)
DTC P0015 Camshaft Position "B" - Timing Over-Retarded
(Bank 1)
DTC P0024 Camshaft Position "B" - Timing Over-Advanced
or System Performance (Bank 2)
DTC P0025 Camshaft Position ...
Diagnosis system
1. CHECK DLC3
The vehicle uses ISO 15765-4 communication
protocol.
The terminal arrangement of the DLC3 complies
with SAE 1962 and matched the ISO 15765-4
format.
If the result is not as specified, the DLC3 may have
a malfunction. Repair or replace the harness and
connecto ...
