(A) select the following menus on the intelligent tester: diagnosis, enhanced obdii, monitor info and monitor result. The monitor status appears after the component name.
(b) Confirm that the component is either PASS or FAIL.
(c) Select the component and press ENTER. The accuracy test value appears if the monitor status is either PASS or FAIL.
HINT:
The monitor result might be PASS on rare occasions even if the Malfunction Indicator Lamp (MIL) is illuminated. This indicates that the system was malfunctioning in the previous driving cycle.
This might be caused by an intermittent problem.
Perform monitor drive pattern
Check component statusProblem symptoms table
SLIDING ROOF SYSTEM
Symptom
Suspected area
AUTO function does not operate
Sliding roof motor assembly
Sliding roof system does not operate
ECU-IG fuse
S/ Roof fuse
IG1 relay
Sliding roof housing assembly
Sliding roof motor switc ...
CD-ROM Abnormal/ CD-ROM Abnormal
DTC 62-43 CD-ROM Abnormal
DTC 63-43 CD-ROM Abnormal
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
62-43
CD-ROM operation is abnormal
CD
Radio receiver
63-43
CD-ROM operation is abnormal
INSPECTION PROCEDURE
HIN ...
Television display
COMPONENTS
Removal
1. REMOVE TELEVISION BASE
Release the 4 clips and remove the television base.
2. REMOVE TELEVISION DISPLAY ASSEMBLY
Disconnect the connector and remove the 4 bolts
and the television display assembly.
Installation
1. INSTALL TELEVISION DISP ...