Toyota Sienna Service Manual: CD Changer Mechanical Error/ CD Insertion and Ejection Error/ CD Reading Abnormal
DTC 63-10 CD Changer Mechanical Error
DTC 63-11 CD Insertion and Ejection Error
DTC 63-12 CD Reading Abnormal
DESCRIPTION
|
DTC No. |
DTC Detection Condition |
Trouble Area |
| 63-10 | A mechanical error in the CD changer is detected while the CD is not being inserted or ejected. | Radio and navigation assembly |
| 63-11 | CD insertion or ejection is failed | |
| 63-12 | CD read problem occurs. |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs
1 REPLACE RADIO AND NAVIGATION ASSEMBLY
END
Camera Picture Error
DTC 5C-40 Camera Picture Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
5C-40
Synchronous signal from the camera cannot be
transmitted.
...
Wrong Disc/ Disc cannot be Read
DTC 63-41 Wrong Disc
DTC 63-42 Disc cannot be Read
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
63-41
An unsuitable disc is inserted
CD
...
Other materials:
Disassembly
1. Remove oil filler cap sub-assembly
(A) remove the oil filler cap sub-assembly and oil filler
gasket.
2. REMOVE SPARK PLUG
(a) Remove the spark plugs.
3. REMOVE OIL PAN DRAIN PLUG
(a) Remove the oil pan drain plug and oil pan drain plug
gasket.
4. REMOVE VENTILATION VALVE SUB-ASSEMBLY
...
Installation
HINT:
Install the RH side by the same procedure as the LH side.
1. INSTALL REAR SPEED SENSOR
(a) Clean the contacting surface of the axle hub and a
new skid control sensor.
NOTICE:
Keep the sensor rotor clean.
(b) Place the speed sensor on the axle hub so that the
connector is positioned ...
Installation
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. INSTALL REAR AIRBAG SENSOR LH
Check that the ignition switch is off.
Check that the battery negative (-) terminal is
disconnected.
CAUTION:
...
