Toyota Sienna Service Manual: Eject Error/ Elevator Error/ Clamp Error
DTC 44-45 Eject Error
DTC 44-51 Elevator Error
DTC 44-52 Clamp Error
DESCRIPTION
|
DTC No. |
DTC Detecting Condition |
Trouble Area |
| 44-45 | Disc cannot be ejected. | Television display assembly |
| 44-51 | Mechanical error occurs during elevator operation. | |
| 44-52 | Error occurs in DVD player clamp. |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.
1 CHECK TELEVISION DISPLAY ASSEMBLY
- Check if a disc can be changed, inserted or ejected normally.
OK: Malfunction disappears
END
DVD Error/ Excess Current/ Tray Insertion / Ejection Error
DTC 44-44 DVD Error
DTC 44-48 Excess Current
DTC 44-50 Tray Insertion / Ejection Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
44-44
Operation ...
Scratched / Reversed Disc
DTC 44-46 Scratched / Reversed Disc
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
44-46
Scratches or dirt is found on DVD surface or DVD is set
...
Other materials:
Adjustment
HINT:
On the RH side, use the same procedures as on the LH
side.
Since a centering bolt is used as door hinge mounting
bolts on the body side and the door side, the door cannot
be adjusted with them on. Substitute a bolt with a washer
for the centering bolt.
1. INSPECT BACK DOOR PAN ...
Circuit inspection
A description of the main areas of each circuit inspection
is shown in the table below.
Item
Description
Circuit Description
The major role, operation of the circuit and its component parts are
explained.
Diagnostic Trouble Code No. and Detection item
Indicates ...
Installation
1. INSTALL FRONT SEAT ASSEMBLY LH
Place the seat assembly in the cabin.
NOTICE:
Be careful not to damage the body.
Connect the connectors under the seat assembly.
Tighten the 2 bolts on the front side of the seat
assembly.
Torque: 37 N*m (375 kgf*cm, 27 ft.*lb ...
